Metal Cutting and Tapping Fluid
Buy Metal Cutting and Tapping Fluid at Metals4u™ online or over the phone on 01937 534318.
CT-90 is specially formulated Cutting/Tapping/Reaming/Drilling lubricant fluid which will not breakdown under extreme pressure. CT-90 will allow the removal of swarf and cut chips of metal by the cutting tool with less friction.
CT-90 allows less effort when cutting is required for even the hardest metal. CT-90 improves the surface finish and cutting times are reduced. This increases production rates and extends cutting and drilling tool life. CT-90 has been formulated to be suitable for all types of steel and ceramics, even high Tensile Steels. Due to the active nature of this product there is a risk of staining if the product is used on some yellow metals such as Copper and Brass. Apply CT-90 before and during the drilling operation which will increase the efficiency and prolong drill bit life. Take caution near moving parts.
Use CT-90 when thread cutting apply to the die or tap prior to use and also during the operation. CT-90 is suitable for both machine and hand operation and is particularly recommended for pipe work where the risk of thread wall deformation during cutting is reduced. Apply CT-90 to the saw blades before and during the sawing operation. CT-90 is suitable for use with power saws and hand saws. Available in aerosol with an extended component for application in those difficult to reach areas.